300-101 | how many questions of 300-101 dumps?

New Questions 4

Refer to the exhibit.

Which one statement is true?

A. Traffic from the 172.16.0.0/16 network will be blocked by the ACL.

B. The 10.0.0.0/8 network will not be advertised by Router B because the network statement for the 10.0.0.0/8 network is missing from Router B.

C. The 10.0.0.0/8 network will not be in the routing table on Router B.

D. Users on the 10.0.0.0/8 network can successfully ping users on the 192.168.5.0/24 network, but users on the 192.168.5.0/24 cannot successfully ping users on the 10.0.0.0/8 network.

E. Router B will not advertise the 10.0.0.0/8 network because it is blocked by the ACL.

Answer: E

New Questions 5

Which protocol uses dynamic address mapping to request the next-hop protocol address for a specific connection?

A. Frame Relay inverse ARP

B. static DLCI mapping

C. Frame Relay broadcast queue

D. dynamic DLCI mapping

Answer: A

New Questions 6

Which method allows IPv4 and IPv6 to work together without requiring both to be used for a single connection during the migration process?

A. dual-stack method

B. 6to4 tunneling

C. GRE tunneling

D. NAT-PT

Answer: A

New Questions 7

When using SNMPv3 with NoAuthNoPriv, which string is matched for authentication?

A. username

B. password

C. community-string

D. encryption-key

Answer: A

New Questions 8

A network engineer configures two connected routers to run OSPF in Area 0; however, the routers fail to establish adjacency. Which option is one of the caused for this issue?

A. Area numbers match.

B. OSPF process numbers do not match on both neighbor routers.

C. The Same MTU sizes are configured on both sides.

D. The Same OSPF router IDs are configured on both routers.

Answer: B

New Questions 9

Which keyword of the aaa authentication ppp command supports PAP only?

A. line

B. krb5

C. local

D. local-case

E. enable

Answer: B

New Questions 10

Which three steps are most helpful in verifying proper route redistribution? (Choose three.)

A. On the routers not performing the route redistribution, use the show ip route command to see if the redistributed routes show up.

B. On the ASBR router performing the route redistribution, use the show ip protocol command to verify the redistribution configurations.

C. On the ASBR router performing the route redistribution, use the show ip route command to verify that the proper routes from each routing protocol are there.

D. On the routers not performing the route redistribution, use the show ip protocols command to verify the routing information sources.

E. On the routers not performing the route redistribution, use the debug ip routing command to verify the routing updates from the ASBR.

Answer: A,B,C

Explanation:

In order to verify proper route redistribution, use the u201cshow ip routeu201d command on all routers within the network, as well as the ABSR, to verify that the routes are properly being advertised to all routers. In addition, issuing the u201cshow ip protocolu201d can be used on the router performing the redistribution to verify that routes are being redistributed into each other.

New Questions 11

Router R1, a branch router, connects to the Internet using DSL. Some traffic flows through a GRE and IPsec tunnel, over the DSL connection, destined for an Enterprise network. Which of the following answers best describes the routeru2021s logic that tells the router, for a given packet, to apply GRE encapsulation to the packet?

A. When the packet received on the LAN interface is permitted by the ACL listed on the tunnel gre acl command under the incoming interface

B. When routing the packet, matching a route whose outgoing interface is theGRE tunnel interface

C. When routing the packet, matching a route whose outgoing interface is the IPsec tunnel interface

D. When permitted by an ACL that was referenced in the associated crypto map

Answer: B

Explanation:

As for the correct answer, the process of routing a packet out a GRE tunnel interface triggers the GRE encapsulation action. As for the incorrect answers: There is no tunnel gre acl command. There is no IPsec tunnel interface. Finally, one answer refers to logic that would describe a routeru2021s logic when determining whether to encapsulate a packet into an IPsec tunnel.

New Questions 12

Which two methods of deployment can you use when implementing NAT64? (Choose two.)

A. stateless

B. stateful

C. manual

D. automatic

E. static

F. functional

G. dynamic

Answer: A,B

New Questions 13

A network engineer notices that transmission rates of senders of TCP traffic sharply increase and decrease simultaneously during periods of congestion. Which condition causes this?

A. global synchronization

B. tail drop

C. random early detection

D. queue management algorithm

Answer: A